Adcon A720 Guía de usuario descargar pdf (Pagina 44)

CHAPTER 2

System Setup

2. Click Connect in the Sensors section (you can also right-click

a sensor and select Connect Sensors from the pop-up). The

window shown Figure 17 is displayed.

Figure 17. Connecting SDI-12 Sensors

3. From the left pane, select the sensor you want to connect and

click the right-arrow button.

4. If you want to edit the name or the SDI address of a sensor

already connected, select the sensor, then click the edit

button and perform the editing.

5. Click OK when you are finished.

6. After connecting the sensors, confirm the changes by clicking

Update or by selecting File

Update.

Disconnecting Sensors

If you want to disconnect (or detach) sensors from one or more

RTUs, do the following:

1. In the Configurator window, expand the RTU tree until you

locate the connector with the sensor you want to disconnect,

then select the sensor.

Note: You can also select multiple RTUs (in addition to connectors)

for bulk disconnecting similar sensors.

2. Click Disconnect in the Sensors section (you can also right-

click a sensor and select Disconnect Sensors from the pop-

up).

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 145 146

Sin comentarios

Adcon A720 Guía de usuario Pagina 44