Adcon A720 Guía de usuario descargar pdf (Pagina 38)

CHAPTER 2

System Setup

Note: The poll schedule is applicable only to the A733GSM/GPRS

RTUs.

Adding New RTUs

If you need to add new RTUs, you first need to know their serial

number, symbolic names (usually the place where they are

installed), and the stations through which they have to be routed, if

any. For the A733GSM/GPRS RTUs, you don’t need a route, but

you will need its data phone number (for more details on the data

phone number issue, please consult the addWAVE User Guide).

Note: The RTU must be first installed in the field. For information

about installing RTUs, consult the respective RTU user

manual.

After you have started the Configurator and logged in (as

described in Step 2 through Step 5 on page 23), proceed as

described below:

1. Click Add in the RTUs section of the Configurator window to

display the window shown in Figure 13.

2. Complete the Name and Code fields and select the

appropriate RTU model (addIT, addWAVE, or A730MD). If you

don’t know which model the RTU is, you can also select

UNKNOWN and the first time the gateway contacts the

device, it will update this information. Note, however, that you

cannot configure sensors until the RTU has been identified.

Note: A733GSM/GPRS RTUs cannot be automatically identified.

3. To specify a starting date for polling the RTU, select the

Collect data since combo box to display a drop-down

calendar, then select the date. By doing this, you won’t have

to wait until the base station retrieves data that you don’t

need from those RTUs with large on-board storages.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 145 146

Sin comentarios

Adcon A720 Guía de usuario Pagina 38