Adcon A720 Guía de usuario descargar pdf (Pagina 23)

CHAPTER 2

Installation

5. Configure your telemetry network.

6. Configure the modem if your network includes A733GSM/

GPRS RTUs.

In order to start and use the Configurator, make sure that your PC

and the gateway are connected either directly via a crossover

network cable, or via a hub or switch in a LAN.

Configure the TCP/IP parameters

If you have already configured the TCP/IP parameters with the

command line interface as described in “Configuring the Network

via a Terminal” on page 19, you can skip this section. If you have

not configured the parameters, continue reading.

By default, the gateway is delivered with a DHCP server enabled,

which means that the server distributes IP addresses to all the

machines on the network requesting one. This might be a problem

if you install the gateway in a LAN where a DHCP server is already

active, so you will have to switch the server off, either via a terminal

or via the Configurator. In the latter case, proceed as follows:

1. Configure your PC’s TCP/IP networking to request its IP

address from a DHCP server. If necessary, consult your PC’s

user manuals to do so.

2. Point your Internet browser to the address of your gateway.

For example, if your gateway was configured as described on

page 21, type http://192.168.1.2 in your browser to

display the welcome page of the A840 Telemetry Gateway.

3. Before continuing, make sure that all the requirements

mentioned on the web page are met by your system (that is,

that the Java VM and the Java WebStart technology are

installed). When you are sure the system requirements have

been met, you can click Configure.

4. The WebStart software starts and, after loading the Java

application, a message appears warning you that the

application requests unrestricted access to your machine and

network. The application is signed with an Adcon Telemetry

certificate that the WebStart software will not recognize, so

you must click Start to proceed.

5. You are prompted for a user name and a password (see

Figure 3). Use the account root, whose default password is

840sw. If you changed the password, use the new one.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 145 146

Sin comentarios

Adcon A720 Guía de usuario Pagina 23