Adcon A720 Guía de usuario descargar pdf (Pagina 18)

CHAPTER 2

System Setup

will need to provide your own “crossover” Ethernet cable, which

you can find in most computer stores.

If you plan to use the base station as a standalone unit (that is,

without a computer), you need a telephone line that must be

connected to the modem jack of the A840 gateway.

Note: Before you operate the base station, Adcon strongly

recommends that you charge the internal battery to a level

where it can sustain the operation of the gateway. You can

do this by plugging the power cable into the A840 device,

but disconnecting the serial cable from the A440 outdoor

unit for at least six hours.

Initializing and Configuring the Base Station

You can use the gateway in one of the following configurations,

depending on your application:

• a new installation

• a replacement for an A730SD with addVANTAGE 3.x

• a replacement for an A730SD and upgrading to

addVANTAGE 4 Pro

New Installation

With a new installation, you will need to install the RTUs in the field

and configure them in addVANTAGE. Refer to the addVANTAGE

software and respective RTU user manuals for additional details.

A730SD Replacement with addVANTAGE 3.x

For the base station to operate properly, you must start the

addVANTAGE 3.x software. Make sure that the software is properly

configured (the serial port and so forth). Refer to the respective

software manual for additional configuration details. If your base

station operates standalone (as dumb server), initiate a call through

addVANTAGE to configure it.

If you are installing the base station as replacement for an A730SD

receiver, just upgrade your addVANTAGE installation to version

3.45 or later (earlier versions don’t support the A840 Telemetry

Gateway). After starting addVANTAGE, your new base station will

be configured automatically.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 145 146

Sin comentarios

Adcon A720 Guía de usuario Pagina 18